Auto Parts Search
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Elantra AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Elantra cars and light trucks from 1990+.
Anti-lock Brakes -> Description
Vehicle: 2000 Hyundai Elantra 2.0 L4 GAS
If a malfunction occurs, the diagnostic system will identify the problem and the ECU will store the codes...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Elantra BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Elantra AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Elantra cars and light trucks from 1990+.
Disc Brakes -> Caliper Service -> Accent -> Assemble -> Disassemble -> Elantra & Tiburon -> Elantra, Sonata & Tiburon -> Front -> Installation -> Rear -> Removal -> Santa Fe -> Sonata -> XG 300 & XG 350
Vehicle: 2000 Hyundai Elantra 2.0 L4 GAS
Front
Accent
Removal
- Remove wheel/tire assembly.
- Remove brake hose from caliper and cap brake line(s).
- Remove caliper assembly as outlined under, "Brake Pad Service."
Disassemble
- Remove sleeve, sleeve boot and pin boots, Fig. .
- Protect fingers with shop towel, then blow piston from caliper bore with compressed air.
- Remove piston boot, then pry piston seal from caliper bore using a suitable screwdriver.
Assemble
- Clean all components with suitable cleaner.
- Inspect caliper bore, piston and carrier for damage or excessive wear.
- Apply suitable rubber grease to new piston seal, then install piston s...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Elantra BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Elantra AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Elantra cars and light trucks from 1990+.
Drum Brakes -> Brake Service -> Accent, Elantra, Sonata & Tiburon -> Inspection -> Installation -> Removal -> Santa Fe
Vehicle: 2000 Hyundai Elantra 2.0 L4 GAS
Removal
Accent, Elantra, Sonata & Tiburon
- Raise and support vehicle, then remove wheel/tire assembly.
- On Accent, Elantra and Tiburon models, remove axle nut, then the hub and drum assembly, Fig. .
- On Sonata models, remove brake drum. If drum is difficult to remove, screw in bolts to pull drum out, Figs. and .
- On all models, remove end shoe springs, cylinder and hold-down spring.
- Remove shoes and adjuster as an assembly.
Santa Fe
- Raise and support vehicle, then remove wheel/tire assembly.
- Remove brake drum Fig. .
- Remove brake shoe hold-down spring and strut.
- Remove brake shoe return springs...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Elantra BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Elantra AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Elantra cars and light trucks from 1990+.
Anti-lock Brakes -> System Service -> 1997-98 -> 1999-2002 -> Accent -> Brake System Bleed -> Component Replacement -> Elantra, Sonata & Tiburon -> Electronic Control Unit (ECU) -> Front Wheel Sensors -> Hydraulic Control Unit (HCU) -> Modulator -> Rear Wheel Sensors
Vehicle: 2000 Hyundai Elantra 2.0 L4 GAS
Brake System Bleed
- Bleed normal brake circuit using standard procedure as outlined in "Hydraulic Brake Service."
- Turn ignition switch Off, then connect MUT to diagnosis connector.
- Turn ignition switch to On position, but do not start engine. Multi-use tester should now be On.
- Follow each of the steps listed in Fig. for each bleed screw in order shown:
- Place a clear plastic bleeder tube on screw to be bled.
- Apply light and constant pressure to brake pedal.
- Use multi-use tester to actuate appropriate valve. As valve cycles, fluid and/or air will emerge from bleed screw and brake pedal will...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Elantra BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Elantra AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Elantra cars and light trucks from 1990+.
Hydraulic Brake Systems -> Component Replacement -> Master Cylinder
Vehicle: 2000 Hyundai Elantra 2.0 L4 GAS
Master Cylinder
- Disconnect electrical connector from fluid level switch, if equipped, Figs. through .
- Disconnect brake lines from master cylinder and plug open ports.
- Remove master cylinder mounting nuts, then remove ma...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Elantra BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 2000 Hyundai Elantra AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 2000 Hyundai Elantra cars and light trucks from 1990+.
Drum Brakes -> Adjustments -> Parking Brake
Vehicle: 2000 Hyundai Elantra 2.0 L4 GAS
Parking Brake
Service brakes must be properly adjusted before attempting to adjust parking brake lever.
- Pull parking brake lever upward with a force of approximately 44 lbs. noting the following:
- On Accent models, a stroke of 5-7 notches on lever is acceptable.
- ...
CLICK HERE TO GET FULL ACCESS TO 2000 Hyundai Elantra BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
More parts |
Get the Complete Technical Service Bulletins! |
Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2000 Hyundai Elantra vehicle. |
Access the Complete guide! |