Auto Parts Search


      Over 40 million used auto parts online. Shop online for auto and truck parts and save up to 75%

Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 2000 Dodge Durango car and truck repair procedures including Dodge engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 2000 Dodge Durango automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

We have info for following modifications of 2000 Dodge Durango

  • 2000 Dodge Durango 4.7 V8 GAS, CID:287, Fuel Injection, Aspiration:287, Engine VIN:, Desg:N
  • 2000 Dodge Durango 5.2 V8 GAS, CID:318, Fuel Injection, Aspiration:318, Engine VIN:, Desg:Y
  • 2000 Dodge Durango 5.9 V8 GAS, CID:360, Fuel Injection, Aspiration:360, Engine VIN:, Desg:Z

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2000 Dodge Durango AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2000 Dodge Durango cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 2000 Dodge Durango 4.7 V8 GAS

  • With vehicle in neutral, position vehicle on hoist.
  • Remove skid plate, if equipped.
  • Remove hub nut from the half shaft.
  • Remove brake caliper and rotor.
  • Remove wheel speed sensor if equipped.
  • Remove hub bearing bolts from the knuckle.
  • Remove hub bearing and brake shield from knuckle.
  • Support half shaft at the C/V joint housings.
  • Position two pry bars behind the inn...

CLICK HERE TO GET FULL ACCESS TO 2000 Dodge Durango DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2000 Dodge Durango AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2000 Dodge Durango cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble -> U-Joint with Injected Rings -> U-Joint with Snap Rings
Vehicle: 2000 Dodge Durango 5.9 V8 GAS

This procedure describes a propeller shaft equipped with a cardan joint in the tube yoke. For propeller shafts equipped with a companion/slip yoke, repeat the steps to remove the remaining cardan joint.

U-Joint with Snap Rings

Disassemble
  • Tap outside of bearing cap with a drift to loosen snap ring.
  • Remove snap rings from both sides of yoke.
  • Position yoke with grease fitting if equipped, pointing up.
  • Position a socket with a inside diameter large enough to receive bearing cap, beneath yoke on a press.
  • Place another socket with an outside diameter smaller than bearing cap on ...

CLICK HERE TO GET FULL ACCESS TO 2000 Dodge Durango DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2000 Dodge Durango AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2000 Dodge Durango cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 2000 Dodge Durango 5.2 V8 GAS

  • With vehicle in neutral, position vehicle on hoist.
  • Remove skid plate, if equipped.
  • Remove hub nut from the half shaft.
  • Remove brake caliper and rotor.
  • Remove wheel speed sensor if equipped.
  • Remove hub bearing bolts from the knuckle.
  • Remove hub bearing and brake shield from knuckle.
  • Support half shaft at the C/V joint housings.
  • Position two pry bars behind the inn...

CLICK HERE TO GET FULL ACCESS TO 2000 Dodge Durango DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2000 Dodge Durango AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2000 Dodge Durango cars and light trucks from 1990+.

DRIVESHAFT, Replace -> Front -> Rear
Vehicle: 2000 Dodge Durango 5.2 V8 GAS

Front

  • With vehicle in neutral, position vehicle on hoist.
  • Remove skid plate, if equipped.
  • Mark a reference line across propeller shaft flange and pinion flange.
  • Remove exhaust crossover bolts from exhaust manifolds and lower crossover.
  • Remove boot clamp from CV joint.
  • Remove pinion flange bolts.
  • Slide propeller shaft off transfer case and remove shaft.
  • Reverse procedure to install, noting the following:
    • Align reference marks.
    • Replace old pinion flange bolts with new bolts and coat with Loctite 242 threadlocker.
    • Torque pinion flange bolts to 65 ft. lbs.

Rear

  • With vehicle in neutral, posit...

CLICK HERE TO GET FULL ACCESS TO 2000 Dodge Durango DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2000 Dodge Durango AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2000 Dodge Durango cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble -> U-Joint with Injected Rings -> U-Joint with Snap Rings
Vehicle: 2000 Dodge Durango 4.7 V8 GAS

This procedure describes a propeller shaft equipped with a cardan joint in the tube yoke. For propeller shafts equipped with a companion/slip yoke, repeat the steps to remove the remaining cardan joint.

U-Joint with Snap Rings

Disassemble
  • Tap outside of bearing cap with a drift to loosen snap ring.
  • Remove snap rings from both sides of yoke.
  • Position yoke with grease fitting if equipped, pointing up.
  • Position a socket with a inside diameter large enough to receive bearing cap, beneath yoke on a press.
  • Place another socket with an outside diameter smaller than bearing cap on ...

CLICK HERE TO GET FULL ACCESS TO 2000 Dodge Durango DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 2000 Dodge Durango AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 2000 Dodge Durango cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 2000 Dodge Durango 5.9 V8 GAS

  • With vehicle in neutral, position vehicle on hoist.
  • Remove skid plate, if equipped.
  • Remove hub nut from the half shaft.
  • Remove brake caliper and rotor.
  • Remove wheel speed sensor if equipped.
  • Remove hub bearing bolts from the knuckle.
  • Remove hub bearing and brake shield from knuckle.
  • Support half shaft at the C/V joint housings.
  • Position two pry bars behind the inn...

CLICK HERE TO GET FULL ACCESS TO 2000 Dodge Durango DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

Click here to view more details about 1998 Dodge Durango Fender, Front, Driver Side1998 Dodge Durango Fender, Front, Driver Side.

Source: Auto Body Parts Store

$83.91

Click here to view more details about 2006 Dodge Durango Grille Assembly2006 Dodge Durango Grille Assembly, With emblem provision, chrome frame, and black grille insert; A high quality, OE replacement complete grille and shell assembly; Backed by 1-year, unlimited-mileage warranty..

Source: Auto Body Parts Store

$113.63

Click here to view more details2002 Dodge Durango 15" X 7" Steel Wheel, STEEL WHEEL, 15 X 7, 6 STUDS/LUGS, 4.5" BOLT DIA, 6 OVAL VENTS, BLACK FULL-FACE, UNIVERSAL; STEEL, , .

Source: Wheels / Rims, Mirrors & Lights Store

$64.45

Click here to view more details2002 Dodge Durango V8, 4.7 L, 285 CID Rebuilt Engine, Warranty: 3-Year/100,000 Mile, .

Source: Rebuilt Engines Store

$2,530.00

Click here to view more details2009 Dodge Durango Used Bumper Bar, Front, 4DR, Black, SLT, Very Good.

Source: Used Auto Parts Store

$256.00

Click here to view more details2002 Dodge Durango Used Rear Vent Window, Driver Side, privacy, Very Good.

Source: Used Auto Parts Store

$88.00
More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 2000 Dodge Durango vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
GOT A WEBSITE?Make money with Automotix

Make money with Automotix Partner Program.

Learn more

Auto Repair Quick Search
Help me find