Auto Parts Search


      Over 40 million used auto parts online. Shop online for auto and truck parts and save up to 75%

Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1999 GMC Sierra 1500 car and truck repair procedures including GMC engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 1999 GMC Sierra 1500 automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

We have info for following modifications of 1999 GMC Sierra 1500

  • 1999 GMC Sierra 1500 4.3 V6 GAS, CID:262, Fuel Injection, Aspiration:262, Engine VIN:, Desg:W
  • 1999 GMC Sierra 1500 4.8 V8 GAS, CID:294, Fuel Injection, Aspiration:294, Engine VIN:, Desg:V
  • 1999 GMC Sierra 1500 5.3 V8 GAS, CID:323, Fuel Injection, Aspiration:323, Engine VIN:, Desg:T

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1999 GMC Sierra 1500 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1999 GMC Sierra 1500 cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 1999 GMC Sierra 1500 4.8 V8 GAS

Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.

Disassemble

  • Support propeller shaft in a line horizontal with table of a press.
  • Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
  • On models equipped with external snap ring retainers, proceed as follows:
    • Disassemble snap rings by ...

CLICK HERE TO GET FULL ACCESS TO 1999 GMC Sierra 1500 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1999 GMC Sierra 1500 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1999 GMC Sierra 1500 cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 1999 GMC Sierra 1500 5.3 V8 GAS

Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.

Disassemble

  • Support propeller shaft in a line horizontal with table of a press.
  • Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
  • On models equipped with external snap ring retainers, proceed as follows:
    • Disassemble snap rings by ...

CLICK HERE TO GET FULL ACCESS TO 1999 GMC Sierra 1500 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1999 GMC Sierra 1500 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1999 GMC Sierra 1500 cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 1999 GMC Sierra 1500 4.8 V8 GAS

  • Raise and support vehicle.
  • Remove wheel and tire assembly.
  • Remove drive axle center cap, if equipped.
  • Insert a drift or large screwdriver through brake caliper into one of the brake rotor vanes in order to prevent drive axle wheel drive shaft from turning.
  • Remove nut and washer from hub. Do not reuse nut. A new nut must be used when installing wheel drive shaft.
  • Using axle remover tool No. J 45859 or equivalent, press wheel drive shaft from hub.
  • Remove bolts securing wheel dr...

CLICK HERE TO GET FULL ACCESS TO 1999 GMC Sierra 1500 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1999 GMC Sierra 1500 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1999 GMC Sierra 1500 cars and light trucks from 1990+.

DRIVESHAFT, Replace -> Front -> Front, All Except NP8 Axle -> Front, NP8 Axle -> One Piece Driveshaft -> Rear -> Three Piece Driveshaft -> Two Piece Driveshaft
Vehicle: 1999 GMC Sierra 1500 4.3 V6 GAS

Front

Front, All Except NP8 Axle
  • Raise and support vehicle.
  • Remove front differential carrier shield, if used.
  • Reference mark relationship of propeller shaft to front axle and transfer case flange.
  • Remove bolts and retainers from front axle.
  • Remove bolts and retainers from transfer case.
  • Remove propeller shaft. When removing propeller shaft, do not attempt to remove shaft by pounding on yoke ears or using a tool between yoke and universal joint. If propeller shaft is removed by using such means, injection joints may fracture and lead to premature failure of joint.
  • Compress propeller...

CLICK HERE TO GET FULL ACCESS TO 1999 GMC Sierra 1500 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1999 GMC Sierra 1500 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1999 GMC Sierra 1500 cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 1999 GMC Sierra 1500 4.3 V6 GAS

  • Raise and support vehicle.
  • Remove wheel and tire assembly.
  • Remove drive axle center cap, if equipped.
  • Insert a drift or large screwdriver through brake caliper into one of the brake rotor vanes in order to prevent drive axle wheel drive shaft from turning.
  • Remove nut and washer from hub. Do not reuse nut. A new nut must be used when installing wheel drive shaft.
  • Using axle remover tool No. J 45859 or equivalent, press wheel drive shaft from hub.
  • Remove bolts securing wheel dr...

CLICK HERE TO GET FULL ACCESS TO 1999 GMC Sierra 1500 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1999 GMC Sierra 1500 AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1999 GMC Sierra 1500 cars and light trucks from 1990+.

CV AXLE SHAFT, Replace
Vehicle: 1999 GMC Sierra 1500 5.3 V8 GAS

  • Raise and support vehicle.
  • Remove wheel and tire assembly.
  • Remove drive axle center cap, if equipped.
  • Insert a drift or large screwdriver through brake caliper into one of the brake rotor vanes in order to prevent drive axle wheel drive shaft from turning.
  • Remove nut and washer from hub. Do not reuse nut. A new nut must be used when installing wheel drive shaft.
  • Using axle remover tool No. J 45859 or equivalent, press wheel drive shaft from hub.
  • Remove bolts securing wheel dr...

CLICK HERE TO GET FULL ACCESS TO 1999 GMC Sierra 1500 DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

Click here to view more details about 2006 GMC Sierra 1500 Mud Flaps, Rear2006 GMC Sierra 1500 Mud Flaps, Rear, Includes stainless steel wax-coated mounting hardware; Made of heavy gauge NeveRust stainless steel; Features a unique contoured design; Designed to protect the paint from mud and debris; Easy installation..

Source: Auto Body Parts Store

$101.72

Click here to view more details2001 GMC Sierra 1500 Turn Signal Switch, Front, Also controls high and low beam dimmer, hazard warning, windshield washer fluid, and wipers; A high quality, OE replacement turn signal switch; With 2 years limited TrustBuilt warranty..

Source: Auto Body Parts Store

$319.23

Click here to view more details about 2007 GMC Envoy Door Mirror, Passenger Side2007 GMC Envoy Door Mirror, Passenger Side, DOOR MIRROR, RH, TEXTURED, POWER, W/SIGNAL LAMP, MANUAL FOLD, CLEAR LENS, , .

Source: Wheels / Rims, Mirrors & Lights Store

$131.50

Click here to view more details2005 GMC Sierra 1500 V8, 5.3 L, 322 CID Rebuilt Engine, 5.3 CHEVY,GMC, Warranty: 3-Year/100,000 Mile, .

Source: Rebuilt Engines Store

$1,866.00

Click here to view more details2001 GMC Sierra 1500 Used Bumper Cover, Front, 12479754-P, Very Good.

Source: Used Auto Parts Store

$265.00

Click here to view more details2003 GMC Sierra 1500 Used Wiper Motor Front, WMF, Very Good.

Source: Used Auto Parts Store

$86.00
More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1999 GMC Sierra 1500 vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
GOT A WEBSITE?Make money with Automotix

Make money with Automotix Partner Program.

Learn more

Auto Repair Quick Search
Help me find