Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1997 Mazda Miata car and truck
repair procedures including Mazda engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 1997 Mazda Miata automobile. Try the Automotix DIY solution today!
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1997 Mazda Miata AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1997 Mazda Miata cars and light trucks from 1990+.
DRIVESHAFT, Replace
Vehicle: 1997 Mazda Miata 1.8 L4 GAS
- Place transmission in neutral, and raise and support vehicle.
- Remove crossmember bracket.
- On models equipped with 16 inch wheel, remove rear crossbar
- Remove presilencer.
- Mark rear companion flange to driveline.
- Mark slip yoke to transmission output shaft.
- Remove bolts and disconne...
CLICK HERE TO GET FULL ACCESS TO 1997 Mazda Miata DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1997 Mazda Miata AUTOMOBILES
Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1997 Mazda Miata cars and light trucks from 1990+.
CV AXLE SHAFT, Replace -> Front
Vehicle: 1997 Mazda Miata 1.8 L4 GAS
Front
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if pulled by mistake. Before performing the following procedures, disconnect the ABS wheel speed sensor connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing vehicle.
- Raise and support vehicle and support it with safety stands in proper locations.
- Remove wheel nuts and front wheels.
- Drain transaxle fluid into suitable container.
- Disconnect ABS wheel speed se...
CLICK HERE TO GET FULL ACCESS TO 1997 Mazda Miata DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 1997 Mazda Miata vehicle.
|
| Access the Complete guide! |
