Auto Parts Search
Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1995 BMW 325I car and truck
repair procedures including BMW engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work
guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up &
drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install
procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c
system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix
your 1995 BMW 325I automobile. Try the Automotix DIY solution today!
BRAKE SERVICE PROCEDURES FOR 1995 BMW 325I AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 BMW 325I cars and light trucks from 1990+.
Anti-lock Brakes -> Description -> ABS Less Stability & Traction Control -> ABS w/Stability & Traction Control
Vehicle: 1995 BMW 325I 2.5 L6 GAS
ABS Less Stability & Traction Control
The Anti-Lock Brake System (ABS) consists of a control unit, hydraulic unit, speed sensors and wiring harness, Fig. , Each speed sensor has a gear wheel which runs past the permanently magnetized edge of the speed sensor installed in the wheel hub. The rotary motion of the wheels is recorded by inductive sensors and an electric signal is sent to the electronic control unit.
The electronic control unit is located in a compartment on the right side of the engine compartment. This control unit inputs acceleration, deceleration and slip factors from ...
CLICK HERE TO GET FULL ACCESS TO 1995 BMW 325I BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 BMW 325I AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 BMW 325I cars and light trucks from 1990+.
Hydraulic Brake Systems -> Description -> Master Cylinder
Vehicle: 1995 BMW 325I 2.5 L6 GAS
Master Cylinder
Operating the brake pedal moves pistons (1 and 4) forward, Fig. . Primary cups (2 and 5) slide over compensation bores (3 and 6), which creates balanced pressure in chambers A and B.
Chamber A acts on front right and rear left brakes. Chamber B serves left front and right rear brakes. If brake circuit fails, the brake pedal travel will increase considerably.
If se...
CLICK HERE TO GET FULL ACCESS TO 1995 BMW 325I BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 BMW 325I AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 BMW 325I cars and light trucks from 1990+.
Disc Brakes -> Brake Pad Service -> 525, 528, 530, 540, 740, 750, 840 & 850 -> Front Brake Pads, Replace -> M3, 328, 323, 325 & 328 -> Rear Brake Pads, Replace
Vehicle: 1995 BMW 325I 2.5 L6 GAS
Front Brake Pads, Replace
M3, 328, 323, 325 & 328
- Raise and support vehicle, then remove front tire and wheel assemblies.
- Remove brake pad wear indicator connector from lefthand side of caliper, Fig. .
- Remove anti-rattle clip, then the caliper sliding bolt plastic caps.
- Lift brake hose out of holder, then remove caliper sliding bolts.
- Remove caliper toward rear.
- Remove brake pads, then suspend caliper from frame with wire.
- Reverse procedure to install, noting the following:
- Compress caliper piston into bore.
- Check fluid level and bleed brake system as required.
- Tighten mounting bolts to ...
CLICK HERE TO GET FULL ACCESS TO 1995 BMW 325I BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 BMW 325I AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 BMW 325I cars and light trucks from 1990+.
Disc Brakes -> Parking Brake Service
Vehicle: 1995 BMW 325I 2.5 L6 GAS
- Remove brake disc as previously described.
- Remove parking brake shoes' return spring using suitable brake spring pliers,
- Turn retainers 90° and remove using retainer tool No. 34 4 000, or equivalent, Fig. .
- remove shoes by rotating outward ...
CLICK HERE TO GET FULL ACCESS TO 1995 BMW 325I BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 BMW 325I AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 BMW 325I cars and light trucks from 1990+.
Power Brake Units -> Diagnosis & Testing -> Brake Booster Vacuum Supply Check -> Function Test -> Hydraulic Booster Supply
Vehicle: 1995 BMW 325I 2.5 L6 GAS
Function Test
- Operate brake pedal 10 times with engine stopped.
- If brake pedal gives, system is okay.
- On models equipped with vacuum booster systems,if brake pedal does not give, check valve, vacuum hose and/or rubber ring between master cylinder and brake booster could be faulty.
- On models equipped with hydraulic booster systems, check for faulty power steering pump, lines, accumulator and hydr...
CLICK HERE TO GET FULL ACCESS TO 1995 BMW 325I BRAKE SERVICE PROCEDURES
BRAKE SERVICE PROCEDURES FOR 1995 BMW 325I AUTOMOBILES
Includes anti-lock brakes, disc, drum, power and hydraulic brake services diagnostics and procedures for domestic and imported 1995 BMW 325I cars and light trucks from 1990+.
Hydraulic Brake Systems -> Precautions -> Battery Ground Cable
Vehicle: 1995 BMW 325I 2.5 L6 GAS
Battery Ground Cable
Prior to service, dis...
CLICK HERE TO GET FULL ACCESS TO 1995 BMW 325I BRAKE SERVICE PROCEDURES
Shop online for auto body parts, engines, wheels, lights...
| More parts |
| Get the Complete Technical Service Bulletins! |
 Access diagrams and repair information such as wiring diagrams,
diagnosis and repair charts, manufacturer
service bulletins, and OEM Part
numbers of your 1995 BMW 325I vehicle.
|
| Access the Complete guide! |
