1993 Chevrolet G20 VAN Driveline, U-Joint & CV Axles Replacement (ONLINE REPAIR MANUALS)

Auto Parts Search


Learn how to repair a car or truck, install or remove parts, wire an engine, reset warning lights, replace fuel filter, fix auto body and more. Get Automotix DIY!
Help me findSearch
Get Full Access Automotix DIY provides automotive consumers and do it yourselfers; the most comprehensive repair information about 1993 Chevrolet G20 VAN car and truck repair procedures including Chevrolet engine diagrams, wiring diagrams, repair work estimating measures, technical service bulletins, auto body work guidance, starter & alternator replacement procedures, serpentine belt replacement procedures, radiator & hose replacement procedures, tune-up & drivability specifications, quick lube illustrations, preventive maintenance guide, engine light reset instructions, parts removal and install procedures, fuel filter replacement directions, component location diagrams, air filter locations & replacement instructions, a/c system specifications, and general auto service procedures. You don't have to be a car mechanic or technician to know how to fix your 1993 Chevrolet G20 VAN automobile. Try the Automotix DIY solution today!
DIY REPAIR SAMPLES > CONTINUE EXPLORING >

We have info for following modifications of 1993 Chevrolet G20 VAN

  • 1993 Chevrolet G20 VAN 4.3 V6 GAS, CID:262, Fuel Injection, Aspiration:262, Engine VIN:, Desg:Z
  • 1993 Chevrolet G20 VAN 6.2 V8 DIESEL, CID:379, Fuel Injection, Aspiration:379, Engine VIN:, Desg:C
  • 1993 Chevrolet G20 VAN 5.0 V8 GAS, CID:305, Fuel Injection, Aspiration:305, Engine VIN:, Desg:H
  • 1993 Chevrolet G20 VAN 5.7 V8 GAS, CID:350, Fuel Injection, Aspiration:350, Engine VIN:, Desg:K
  • 1993 Chevrolet G20 VAN Sportvan 4.3 V6 GAS, CID:262, Fuel Injection, Aspiration:262, Engine VIN:, Desg:Z
  • 1993 Chevrolet G20 VAN Sportvan 6.2 V8 DIESEL, CID:379, Fuel Injection, Aspiration:379, Engine VIN:, Desg:C
  • 1993 Chevrolet G20 VAN Sportvan 5.0 V8 GAS, CID:305, Fuel Injection, Aspiration:305, Engine VIN:, Desg:H
  • 1993 Chevrolet G20 VAN Sportvan 5.7 V8 GAS, CID:350, Fuel Injection, Aspiration:350, Engine VIN:, Desg:K

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1993 Chevrolet G20 VAN AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1993 Chevrolet G20 VAN cars and light trucks from 1990+.

DRIVESHAFT, Replace -> One Piece Driveshaft -> Two Piece Driveshaft
Vehicle: 1993 Chevrolet G20 VAN 6.2 V8 DIESEL

One Piece Driveshaft
  • Raise and support vehicle.
  • Mark rear universal joint to drive shaft flange.
  • Remove retaining bolts and clamps.
  • Remove propeller shaft from pinion drive flange.
  • Remove propeller shaft from transmission/transfer case.
  • Using tape or a rubber band, wrap the U-Joint bearing caps to ensure bearing caps do not separate from U-Joint.
  • Reverse procedure to install, noting the following:
    • Align reference marks made during removal.
    • Torque yoke retainer bolts to 18 ft. lbs.
Two Piece Driveshaft
  • Raise and support vehicle.
  • Suppor...

CLICK HERE TO GET FULL ACCESS TO 1993 Chevrolet G20 VAN DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1993 Chevrolet G20 VAN AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1993 Chevrolet G20 VAN cars and light trucks from 1990+.

DRIVESHAFT, Replace -> One Piece Driveshaft -> Two Piece Driveshaft
Vehicle: 1993 Chevrolet G20 VAN 5.0 V8 GAS

One Piece Driveshaft
  • Raise and support vehicle.
  • Mark rear universal joint to drive shaft flange.
  • Remove retaining bolts and clamps.
  • Remove propeller shaft from pinion drive flange.
  • Remove propeller shaft from transmission/transfer case.
  • Using tape or a rubber band, wrap the U-Joint bearing caps to ensure bearing caps do not separate from U-Joint.
  • Reverse procedure to install, noting the following:
    • Align reference marks made during removal.
    • Torque yoke retainer bolts to 18 ft. lbs.
Two Piece Driveshaft
  • Raise and support vehicle.
  • Suppor...

CLICK HERE TO GET FULL ACCESS TO 1993 Chevrolet G20 VAN DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1993 Chevrolet G20 VAN AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1993 Chevrolet G20 VAN cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 1993 Chevrolet G20 VAN 4.3 V6 GAS

Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.

Disassemble

  • Support propeller shaft in a line horizontal with table of a press.
  • Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
  • On models equipped with external snap ring retainers, proceed as follows:
    • Disassemble snap rings by ...

CLICK HERE TO GET FULL ACCESS TO 1993 Chevrolet G20 VAN DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1993 Chevrolet G20 VAN AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1993 Chevrolet G20 VAN cars and light trucks from 1990+.

DRIVESHAFT, Replace -> One Piece Driveshaft -> Two Piece Driveshaft
Vehicle: 1993 Chevrolet G20 VAN Sportvan 5.0 V8 GAS

One Piece Driveshaft
  • Raise and support vehicle.
  • Mark rear universal joint to drive shaft flange.
  • Remove retaining bolts and clamps.
  • Remove propeller shaft from pinion drive flange.
  • Remove propeller shaft from transmission/transfer case.
  • Using tape or a rubber band, wrap the U-Joint bearing caps to ensure bearing caps do not separate from U-Joint.
  • Reverse procedure to install, noting the following:
    • Align reference marks made during removal.
    • Torque yoke retainer bolts to 18 ft. lbs.
Two Piece Driveshaft
  • Raise and support vehicle.
  • Suppor...

CLICK HERE TO GET FULL ACCESS TO 1993 Chevrolet G20 VAN DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1993 Chevrolet G20 VAN AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1993 Chevrolet G20 VAN cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 1993 Chevrolet G20 VAN Sportvan 6.2 V8 DIESEL

Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.

Disassemble

  • Support propeller shaft in a line horizontal with table of a press.
  • Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
  • On models equipped with external snap ring retainers, proceed as follows:
    • Disassemble snap rings by ...

CLICK HERE TO GET FULL ACCESS TO 1993 Chevrolet G20 VAN DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES FOR 1993 Chevrolet G20 VAN AUTOMOBILES

Includes CV axle, universal joint, and driveline replacement, for domestic and imported 1993 Chevrolet G20 VAN cars and light trucks from 1990+.

DRIVESHAFT U-JOINT, Replace -> Assemble -> Disassemble
Vehicle: 1993 Chevrolet G20 VAN Sportvan 5.7 V8 GAS

Never clamp propeller shaft tubing in a vise. Clamping could dent or deform the tube causing an imbalance or unsafe condition. Always clamp on one of the yokes and support the shaft horizontally. Avoid damaging the slip yoke sealing surface. Nicks may damage the bushing or cut the lip seal.

Disassemble

  • Support propeller shaft in a line horizontal with table of a press.
  • Mark propeller shaft in order to show which end connects to transmission and which end goes to rear axle.
  • On models equipped with external snap ring retainers, proceed as follows:
    • Disassemble snap rings by ...

CLICK HERE TO GET FULL ACCESS TO 1993 Chevrolet G20 VAN DRIVELINE, U-JOINT & CV AXLES REPLACEMENT PROCEDURES

Shop online for auto body parts, engines, wheels, lights...

More parts
Help me findSearch
Auto Repair Quick Search
Help me find
Search DIY repair manuals by VIN...
Vehicle Identification Number is a unique serial number used by the automotive industry to identify individual motor vehicles

Find out what info we have for your vehicle

Get the Complete Technical Service Bulletins!
Get the Complete Technical Service Bulletins!Access diagrams and repair information such as wiring diagrams, diagnosis and repair charts, manufacturer service bulletins, and OEM Part numbers of your 1993 Chevrolet G20 VAN vehicle.
Access the Complete guide!
Need To Fix Your Car or Truck?
Save Money With Free Car Insurance Quote
FREE car insurance quote
Enter Zip Code:
Auto Repair Quick Search
Help me find